Filter
Top Products
This potentiometer allows adjustment of the global gain from 24dB to 85dB, and with PAD on from -6dB to 30dB.
The gain control should be used with great care since the adjustment range is extensive.
4.4 L.F. CUT
Low frequency filter at fixed slope 12dB per octave. The cutting frequency is progressively adjustable from 20Hz to
500Hz.
NOTE :
This filter is not disconnected by switching off the EQ push-button.
RETURN TO TABLE OF CONTENTS
5. MASTER MODULE
5.1 Master faders
There are two separate faders to permit different adjustments between right and left. Calibration position (0dB) is
at the end of the fader stroke length.
5.2 Monitor level & mono test
The control section of the SONOSAX SX-S includes the modulometer, the output listening (phones) and the output
monitor. As long as no PFL button has been switched on, the modulometer and the output listening are controlled
by the main L+R output signal. As soon as a PFL button is depressed, the modulometer and the output listening
automatically switch over to the input selected.
NOTE:
It is normal to hear a clicking sound as the buttons are depressed. Under no circumstance does this sound
go through the main output or any of the modulation outputs.
The MONO push-button switches the modulometer and monitor output listening to Mono in order to easily detect a
phase error. This button does not in any way affect the main output. The MONITOR output gives the same
modulation as the monitor output listening at +6 dBu,to feed, for instance, a power amplifier.
5.3 AUX master
The AUX potentiometer regulates the general mixing level of the inputs (3.9). This output is connected with a Mini-
Jack. Nominal level is +6dBu, ground compensated.
Seite 9 von 22SONOSAX SX/S USER MANUAL
26.08.2004file://D:\Z
_
Librar
y
\Webco
py
\sonosax\SXS\sxsume.html