Filter
Top Products
¡
p. 47
master section
aux send level 5-8
These knobs adjust the amount of signal sent to the corresponding AUX buses. Unity gain
occurs at the zero setting, with 6dB additional gain available above that. Note: The Aux
Sends default to buses 5-8. To send to auxes 1-4 internal solder blob jumbers are avail-
able.
PRE
The default signal source for these AUX SENDS is post-fader. These switches are used
for selecting the Pre-fader signals for Auxes 5-8 (or 1-4 if solder blobs have been changed).
The normal Pre-fader signal is derived Post-EQ.
When button is in the “OUT” position, aux sends are Post-EQ, Post-fader.
When button is in the “IN” position, aux sends are Post-insert, Post-EQ, Pre-fader.
level
This knob adjust the amount of signal sent from the ambience input to the assigned bus
and to the ambient level controls on the alternate outputs. Unity gain occurs at the zero
setting, with 10dB additional gain available above that.
mute
This button toggles between the ambience output level (100) and
the mute level. The LED illuminates when mute is active. The ambi-
ence mute functions through the programmable mute scenes.
When button is in the “OUT” position, the level is controled by the
ambience level (100).
When button is in the “IN” position, the level is controlled by the
mute level (102).
mute level
This knob adjusts the amount of signal sent from the ambience input to the assigned bus
when the mute button has been engaged. Unity gain occurs at the zero setting, with 10dB
additional gain available above that.
98
98
99
100
101
99
100
101
102
Setting the ambience
mute level allows the
user to preset two ambi-
ence levels. Use the ambi-
ence mute button to select
the mute level for spoken
word and the main ambi-
ence level for music.
+
102
NOTE: When chang-
ing the aux sends,
be certain to cut
and solder in correct pairs
(aux 1/5, 2/6, 3/7, and 4/8.) For
example, if changing to Aux
1, be certain to remove the
solder on Aux 5.
+