Filter
Top Products
19 . UP/DOWN
The UP/DOWN buttons are for selecting effect presets. Keeping a button
pressed continuously lets you step quickly through the program numbers.
20. FX ON
This switch switches an internal FX unit on and the green LED lights. Please
keep in mind that you can also use an external footswitch for the switching
of the FX unit. In this case, the LED also shows the actual operational status
of the FX unit. If you want to use a footswitch, the FX ON switch has to be
engaged fi rst. The corresponding FX unit is activated and you can use the
footswitch to switch the selected effect program on or off.
21. PEAK LED
These indicators signal if the internal FX units or the AUX 1/2 SEND signals
are on the verge of clipping. To achieve an adequate S/N ratio, please adjust
the FX units’ input level as follows:
Setting Instructions:
1. Establish a “dry” mix – without effect settings – according to the
previous descriptions.
2. Position the effect return fader of the corresponding effect channel at
the –5dB mark.
3. Use the UP/DOWN buttons to select the desired FX program preset.
4. Press the FX ON switch.
5. Play (start the reproduction of) the sound source connected to the
desired input channel and adjust the desired amount of the FX signal,
using the AUX/FX controls of this input channel. Repeat this step for all
input channels that you want to include in your effect mix.
6. Monitor the Peak LED so that it only lights frequently at highly dynamic
signal peaks. When clipping occurs, reduce the AUX/FX controls in the
channels.
7. Use the FX to AUX control to add the effect mix to the monitor mix. Use
the FX return faders to add the desired amount of the FX signal to the
main mix.
In case you are using a different effect setting for the second FX unit, you
have to repeat steps 2 - 7, respectively. Pay some attention to the peak
indicators when operating your PowerMate to be able to quickly interact
when the signal levels exceed the normal range and enter clipping.
22. EFFEKT RETURN
These stereo faders are used to determine the effect amount added to
the main mix. In case you have to set these faders at a position above the
+5dB mark, please check if the FX unit’s input signals are adjusted properly.
Otherwise use the AUX/FX SEND controls to increase the input levels.
FX1/FX2
31