Filter
Top Products
• Correct the pCap firmware version shown in the property page.
• Support both new and old firmware for Optical touch monitors.
• Provide options to limit number of touches (please see Readme).
• IDS improvements: slow response, incorrect initial touch status, incorrect power status report.
Release 6.2.1
• Check the 2521 controller firmware version then apply onboard calibration if it's 6.2 or newer.
• Need to retrieve controller firmware version from the iProduct field for certain controllers.
• IDS: set/get monitor power status using Elo VCP codes.
Release 6.3.0
• Border touch warning for 2515-07 monitors.
• Calibration of multiple monitors in spanned display mode.
• Bug fix where for certain touch monitors (IntelliTouch 2500S / S-Cap 5020), the user is
continuously being prompted to calibrate their touch monitor(s) after reboot.
• Bug fix for not mapping touch to display after calibration is performed in Windows 8.1.
• Bug fix for partially removing Elo files after user confirmed not to proceed with uninstallation.