Filter
Top Products
-2-
H7582 Manual Update
Neck (See Manual Page 10)
The following component has been revised.
Components Needed Qty
Chrome Plated Screws #7 x 1
1
⁄2" ...................... 1
Follow Step 1, then follow the revised steps
below.
2. Turn the guitar face down.
3. Insert a
3
⁄32" drill bit through each of the neck
mounting holes and mark the pilot hole loca
-
tions.
4. Remove the neck, then drill
3
⁄4" deep holes in
the neck. Do not drill deeper than
3
⁄4" or the
bit could go through the top of the fretboard.
5. Place the neck in the neck pocket, place the
neckplate over the neck pocket holes, and
secure the neck to the guitar with #7 x 1
1
/2"
chrome plated screws as shown in
Figure 2.
Figure 2. Neckplate installation.
6. Turn the guitar face up and place a long
straightedge along the center of the fretboard
and mark the center line, as shown in
Figure
3.
Note: You may want to cover the marking
location with masking tape to avoid scratch
-
ing the finish.
7. Measure 25
1
/16" from the fretboard side of the
nut to the right side of the body and draw a
vertical line as shown in
Figure 4. This line
will mark the neck-facing edge of the bridge.
Figure 4. Marking front of bridge.
Front of
Bridge Mark
Figure 3. Marking center line.
Center Line
Mark