Filter
Top Products
H7582 Manual Update
-7-
Figure 18. Bridge placement.
Exposed
Section
Ground
Wire
2. Secure the cover with #2 x
1
⁄4" black screws.
Bridge (See Manual Page 14)
To attach the bridge to the guitar body:
1. Make sure the end of the grounding wire
(Figure 18) protrudes through the angled
hole (drilled earlier) to make contact with the
bridge.
2. Secure the wire in the hole with rubber
cement, leaving the end exposed.
3. Using a
1
⁄16" bit, drill
3
⁄4" deep holes for the
bridge mounting holes.
4. Secure the bridge with five #4 x
3
⁄4" chrome
plated screws.
Figure 17. Circuit board cover installed.
Strap Button (See Manual Page 15)
The following component has been revised.
Components Needed Qty
Felt Buttons .......................................................
2
To attach the strap to the guitar:
1. Using a
1
⁄16" bit, drill holes for the strap but-
tons in the locations shown in
Figure 19, then
secure each strap button with a felt disc and
a #4 x
3
⁄4" chrome plated screw.
Figure 19. Strap buttons.
String Retainers (See Manual Page
16)
The following component has been revised.
Components Needed Qty
Chrome Plated Screws #2 x
3
⁄8" ........................ 2