Filter
Top Products
-4-
H7582 Manual Update
5. Insert the pickup into the mortise, positioning
each #3 x
3
⁄4" black screw through a spring.
6. Secure the pickup to the guitar body with the
black screws. Be careful NOT to thread the
screws through the pickup wire.
7. Turn the guitar over so the back is face-side
up.
8. Solder the pickup wire onto the volume con-
trol as shown on the Wiring Diagram on
Page 8 of this Manual Update.
Speaker (See Manual Page 11)
To install the speaker:
Follow the revised steps below:
1. Place the speaker and mesh cover into the
bottom of the speaker mortise.
2. Using a
1
⁄16" bit, drill four
1
⁄8" deep holes at a
shallow angle slightly above the mesh cover
(see Figure 9).
Figure 9. Drilling speaker mounting holes.
3. Secure the speaker with four #2 x
1
⁄4" black
screws (see Figure 10
). Make sure the
screws are tight enough that the speaker will
not move.
4. Insert the two black wires on the headphone
jack through holes in the circuit board and
battery case
mortises (Figure 11) and into
the speaker mortise.
Figure 11. Speaker wires in battery case
mortise.
Figure 10. Fastening speaker with screws.
5. Solder the wires onto the speaker as shown
on the Wiring Diagram on
Page 8 of this
Manual Update
.
6. Place the speaker cover on the guitar, mark
the four mounting holes and, using a
1
⁄16" bit,
drill
3
⁄16" deep holes.
7. Secure the cover with #2 x
1
⁄4 black screws.