Filter
Top Products
3
Introduction
HONEYWELL™ Wind Turbine WT6500 Owner’s Manual - Rev 10
Before Installing the HONEYWELL™ Wind Turbine:
IMPORTANT
Please take note that the HONEYWELL™ Wind Turbine is a proprietary wind driven
electric generator. It is designed to displace annual electric consumption by connecting
it to the electric switch board in the proper procedures described in this Owner’s
Manual. It may also be used on a stand-alone installation where connecting to a local
electric grid is not possible. Its unique and high efciency design enable it to work in
very low wind areas starting at 2 miles per hour (mph) and much higher (to 38 mph).
Please follow the Site Selection guidelines for optimal installation.
The HONEYWELL™ Wind Turbine is an electric generator. Only licensed and trained
personnel can perform the following installation and maintenance functions:
• Open and work on the SMARTBOX™ Control Equipment.
• Open and work on the Junction Box at the turbine
• Apply any torque to any of the turbine’s fasteners
The installation directions include recommendations of a variety of options. Installation
must be approved and certied by your local Professional Engineer (PE) and the
installer must acquire all the necessary permits from the local authorities prior to
installation.
Your installer must use only proper grounding methods as stipulated by the NEC or
CEC if in Canada.
The HONEYWELL™ Wind Turbine is an electric generator. Therefore high voltage
is generated within the system. Be sure to only use installers and maintenance
professionals to perform work on this turbine.
Failure to complete and mail in the registration card will affect the Warranty.
Failure to use a licensed and trained installer or follow local codes will
adversely affect the warranty coverage and possibly void your
warranty.
Please contact WindTronics if there is any doubt or concern regarding this electric
generator or its installation.
1-877-946-3898