Filter
Top Products
12
HONEYWELL™ Wind Turbine WT6500 Owner’s Manual - Rev 10
Turbine Installation
following designs and their included specications.
See page 34 in the Appendix for design and specications.
Ballast Mount
See page 35 in the Appendix for design and specications.
Turbine Wiring
ELECTRIC SHOCK HAZARD
Disconnect turbine and battery circuits before wiring.
Turn off all power before wiring. Failure to follow safety
warning could result in serious injury and/or death.
Personal Injury and Property Damage Hazard
STOP! If you plan to connect the HONEYWELL™ Wind
Turbine to any controller other than the SMARTBOX™
Controller, immediately cease the installation of the
HONEYWELL™ Wind Turbine. Failure to follow this
warning will void the HONEYWELL™ Wind Turbine
warranty and may result in death, personal injury or
property damage (including damage to the HONEYWELL™
Wind Turbine).
PROFESSIONAL INSTALLATION required
Installations must meet all local electrical codes. Installations for the equipment should
only be performed by a qualied electrician or a licensed and trained WindTronics
installer.
The wiring connections between a mounted HONEYWELL™ Wind Turbine, Battery
Box and SMARTBOX™ Controller is relatively simple. The following diagram details
and species the wire gauges required in this installation. It is strongly recommended
that a certied and trained electrician performs all the electrical connection. All
electrical systems must be grounded in accordance to the National Electric Code
(NEC) (or, in Canada, the Canadian Electric Code (CEC)) and local standards. Please
refer to the SMARTBOX™ Controller Manual for full details on wiring, connecting and
commissioning of the HONEYWELL™ Wind Turbine.