Filter
Top Products
36 Chapter 6
3 With the finished surface (woodgrain) facing forward, curve (bow) the back panel
slightly and fit it into the grooves of the side panel.
4 Use screws (b) to fasten the side panels.
Start by fastening the bottom edge of the back panel (four locations). In two loca-
tions, pass the screw through a cable holder to attach it to the stand. Attach the
power cable holder at either the right side or the left side depending on the location
of the AC outlet you’ll be using.
Then fasten the top edge of the back panel (two locations). Don’t tighten these
screws completely yet, since you’ll be adjusting this area after you attach the instru-
ment to the stand.
5 Make sure that the stand is not tilted and that there are no gaps in it, and then firmly
tighten all of the screws, except for the two screws you left untightened.
Slightly curve the back panel,
and fit it into the grooves
Grooves in side panels
Finished
surface
Fasten the cable holders
at the left or right side
(for the power cable)
Leave untightened
Attach together with
a cable holder
(for the pedal cable)