Filter
Top Products
18
Sostenuto pedal
The damper effect will be applied only to the notes that were already being held
down when you pressed this pedal, and those notes will be sustained while you
continue holding down the pedal. The damper effect will not be applied to notes
that were played after you pressed this pedal.
Soft pedal
While you hold down this pedal, the sound will be softer and more mellow. The
degree to which you press this pedal will change the amount of the soft pedal effect
(i.e., half-pedaling is supported).
Pedal settings in Layer mode
If desired, you can make the damper pedal apply only to one of the two sounds in
Layer mode.
This setting will be reset when you turn off the power. You can use the Data
Dump function to save the settings on an external MIDI data filer (“MIDI
data dump” on page 29).
1. While holding down the TRANSPOSE/FUNCTION button, press the damper
pedal.
Each time you press the pedal, the indicator above the sound select buttons
you’ve selected for layering will light alternately or together.
2. When the indicator above the sound select button for the sound that you want
to use the pedal effect is lit, release the TRANSPOSE/FUNCTION button.
Metronome
You can adjust the tempo and time signature of the metronome, and select an accent.
Turning the metronome on/off
When you press the METRONOME button the indicator will light and the metro-
nome will start at the tempo indicated by the TEMPO slider. To stop the metronome,
press the METRONOME button once again.
Adjusting the metronome volume
To lower the volume, hold down the METRONOME button and press the
[STRING/PAD] sound select button (or the B5 key) several times.
To raise the volume, hold down the METRONOME button and press the [CHOIR]
sound select button (or the C6 key) several times.