Filter
Top Products
19
Resetting to the Factory Setting
To reset the BEATLAB to the factory setting,
switch the power on while pressing the PROG
key and the WRITE key. All the preset values
are reset to the factory set values.
Battery Power Warning
When the battery power of the BEATLAB runs
down, the battery mark appears on LC display.
Replace the batteries with new ones as soon as
possible.
Replacing the Batteries
When the battery power of the BEATLAB runs
down, the replayed sounds may be distorted and
the LC display and the tempo indicators may
darken.
Malfunction may occur. When the battery mark
appears on the LC display, replace the batteries
with new ones as soon as possible.
Replacing the batteries
(1)Be sure to switch the power off using the
STANDBY/ON switch.
(2) Slide the battery cover located on the rear
side of the BEATLAB in the direction of the
arrow.
(3) Replace the old batteries with the new ones
being careful to observe the correct polarity,
then close the battery cover.
(4) Switch the power on by pressing the