Filter
Top Products
© National Instruments Corporation 5 Embedded Module for Blackfin Processors
Installing the EZ-KIT Lite or Emulator
Caution Be careful when removing the board from the package and handling the board to
avoid the discharge of static electricity, which might damage some components.
The EZ-KIT Lite or USB-based ICE board is designed to run as a
stand-alone unit. You do not have to open the computer case.
Note You must install VisualDSP++ before you can install the Blackfin target. Refer to
the Installing the Embedded Module for Blackfin Processors section for information about
installing VisualDSP++.
Complete the following steps to install the EZ-KIT Lite or USB-based ICE.
1. Plug the power supply for the board into a surge-protected outlet.
Connect the USB assembly for the board to the USB port on the host
computer using the provided USB cable.
Figure 1 shows the location of the A/C adaptor and USB port on the
Blackfin target. Refer to the ADSP-BF537 EZ-KIT Lite Evaluation
System Manual in the EZ-KIT box for more detailed information about
the ADSP-BF537 EZ-KIT Lite hardware.
Figure 1. Locating the A/C Adaptor and USB Port on the Blackfin Target
A/C Adaptor
USB to Host PC
ANALOG
DEVICES