Embedded Module for Blackfin Processors 6 ni.com
On the board, the power LED illuminates, and you might see other
visible activity, such as blinking LEDs. The connection activates the
Windows Found New Hardware Wizard.
2. Follow the instructions on the screen to install the software
automatically. A Windows message notifies you when the new device
is ready for use and the hardware installation is complete.
3. Verify that the USB monitor LED is lit. The LED is in close proximity
to the USB connector. The lit LED signifies that the board is
communicating properly with the host computer and is ready to run.
Refer to the ADSP-BF537 EZ-KIT Lite Evaluation System Manual in
the EZ-KIT box for more detailed information about the USB monitor
LED.
4. For a USB-based ICE, attach the JTAG cable to the emulation target.
Refer to the emulator documentation for more information about
USB-based ICE.
Upgrading to the Embedded Module for Blackfin
Processors 2.0
This section describes upgrade and compatibility issues for the Embedded
Module for Blackfin Processors 2.0.
Embedded Project Manager
The Embedded Module for Blackfin Processors no longer supports the
Embedded Project Manager. Use the Project Explorer window instead.
Refer to the Creating the LabVIEW Project section for information about
using the Project Explorer window. Refer to the Upgrading Blackfin VIs
and Embedded Projects section for information about converting
embedded project (
.lep) files.
Upgrading Blackfin VIs and Embedded Projects
If you created Blackfin VIs using the Embedded Module for Blackfin
Processors 1.0, you must create projects and update the VIs for use with
LabVIEW 8.2.1 and the Embedded Module for Blackfin Processors 2.0.
Caution National Instruments recommends you back up your files before you
begin updating your Blackfin VIs for use with the Embedded Module for Blackfin
Processors 2.0. The Embedded Module for Blackfin Processors 1.0 cannot open VIs
you save in version 2.0.
The Embedded Module for Blackfin Processors includes a utility to
help you convert LabVIEW 7.1 embedded project (
.lep) files to