Filter
Top Products
15
Figure 14. Typical CRS System Connections
CONNECTIONS
The CRS-101 System requires only a few simple connections and sets up in minutes. The only required
connections are the IR Sensors, Speakers and Power Cord. Connecting an optional audio source such
as a CD/DVD Player, VCR, Computer, Projector, Cable, Satellite, etc is also simple using standard RCA-
RCA audio patch cables.
IR Sensors
1. Connect the CRS-IRS IR Sensor mini plugs to any two of the three IR Sensor Inputs on the CRS-
CASE Side Panel.
Speakers
1. Strip approximately ¼” off each lead and twist the ends so there are no loose strands that can cause
shorts. The recommended speaker wire size is 14 to 16 gauge.
2. Connect to the appropriate + and – Speaker Terminal. Maintain polarity from the speaker.
NOTE: Though the CRS has Left and Right Line Inputs, the Speaker Outputs are mono, so BOTH
channels will be output from BOTH speakers.