Filter
Top Products
19
Basic Operation
Power-On
1
Use the supplied power cord to connect this unit to an AC power source.
2
Press the POWER button.
To specify the initial state of the unit when it is restarted
Use the [MODE] submenu of the [SETUP] menu to set the startup mode ( page 22).
Preset mode: The last settings are restored when the unit is restarted. The factory default setting is this mode.
Reset mode: The factory default settings are restored when the unit is restarted. However, some settings remain in the
previous state including those of the [SETUP] menu.
Factory default mode: The factory default settings are restored when the unit is restarted.
Power-Off
Keep pressing down the POWER button for 3 seconds or more, and the power of this unit is turned off.
Initial Setup
When you use Panasonic AG-HMX100P/HMX100E for the rst time, you need to make the settings as described below with
the [SETUP] menu (
page 22) and [INT VIDEO] menu ( page 28) to set up this unit.
Setting the startup mode (• page 22)
Changing direct patterns (• page 23)
Setting video and audio input sources (• page 24)
Setting the video format (• page 26)
Setting the bus (• page 27)
Setting the audio output channels (• page 27)
Setting the audio fader (• page 27)
Setting the back matte video (• page 29)
Outputting the color bars (• page 30)
Setting still pictures or movies (• page 30)
Setting video created on PC (• page 32)
HD/SD Settings
This unit is not available for mixing different formats of input signals. Thus, it cannot input HD video and SD video at the
same time to perform the mixing operation.
Depending on whether to input HD video or SD video as an input source, the system format of this unit must be set to “HD”
or “SD,” respectively in the following way.
The system format can be changed from the [VIDEO FORMAT] submenu of the [SETUP] menu (
page 25).
To set the system format to HD: Select 720/50p, 720/59p, 1080/50i, or 1080/59i.
To set the system format to SD: Select 480/59i or 576/50i.