Filter
Top Products
Output features
Output Connectors - Each Group
Group Out
Male XLR carries the post fader Group output signal. This output is designed to
drive output impedances greater than 600 ohms. The associated group metering follows
signal levels that appear on this output connector.
Insert Send & Return
Separate 1/4" TRS jacks are used for pre fader insert connectors. Signal is fed
full time to ground compensated insert send connector. When a connector is
plugged into the fully balanced 1/4" return jack, the internal signal path is broken, with the
external (processed) signal continuing its signal flow through the module. This pair of con-
nectors is used to "patch" external signal processing such as 1/3 octave EQ into the mod-
ule’s signal path.
Local return
1/4” TRS jack- Balanced (can accept balanced or unbalanced inputs).This input
feeds the group by way of the front panel "Local Return" controls. This may be used to
bring effects inputs or external mixes into the mix group output channel.
Common return (On Rear of Module 5-8)
A pair of 1/4” TRS jacks- Balanced (can accept balanced or unbalanced inputs).
Signals into these jacks are sent to the Common-return controls on the Master module.
Two separate inputs are provided to allow a common left and right signal to feed any of the
12 group mix output channels. Master On switches are provided as well as pre and post
fader Solo switching and master level controls. This section may be used to feed reference
or click tracks to any of the 12 main output mixes,or common ambience effects.
T= IN
+
R= IN
–
S= GND
T= IN
+
R= IN
–
S= GND
T= OUT
+
R= G COMP
S= GND
p.27
Output groups
2