Filter
Top Products
13
Deutsch Français Italiano Español Português NederlandsEnglish
Display Value Explanation
C66
CC66 ( SOSTENUTO)
Sustain the notes that are currently
being held down.
C71
CC71 ( RESONANCE)
Control the resonance. Increasing
the resonance value will produce
a distinctive tonal character that is
typical of a synthesizer.
C72
CC72 ( RELEASE TIME)
Control the time from note-o (when
the key is released) until the sound
is no longer heard (i.e., the release
time).
C73
CC73 ( ATTACK TIME)
Control the sharpness (attack speed)
with which the sound begins.
C74
CC74 ( CUTOFF)
Control the cuto . Higher values will
make the sound harder (brighter);
lower values will make the sound
softer (more mellow).
AFt
AFTERTOUCH
(Default)
Apply the most suitable e ect for
each of the Lucina AX-09’s tones.
Adb
ADLIB
By ngering a chord and moving
your hand above the D Beam
controller, you can produce an
arpeggio of that chord.
The distance from the D Beam
controller will determine the octave
span of the chord that is played, and
the speed at which you move your
hand up and down will determine
the speed at which the chord is
arpeggiated.
For example if you use your right
hand to hold down the four notes
“C D E G” and move your left hand
above the D Beam controller, a
phrase such as “C D E G C D E G C D E
G...” will play.
SLo
SOLO SYNTH
The Lucina AX-09 will operate as a
monophonic synthesizer whose pitch
can be controlled by moving your
hand above the D Beam controller.
MEMO
By holding down the [INC/+] / [DEC/–] button you can
choose this setting rapidly. To choose even faster, hold
down the button and press the other button as well.
3. Release the [SHIFT] button.
4. To save this setting, hold down the [SHIFT] button
and press the [WRITE] button.
Using a Foot Pedal
If you connect a pedal switch (DP series; sold separately)
to the FOOT PEDAL jack, you can hold down the pedal to
make notes continue sustaining even after you release the
keyboard.
Alternatively, you can use the pedal to apply numerous
other e ects.
Connecting a foot pedal
MEMO
Alternatively, you can connect an expression pedal
(EV-5) instead of a pedal switch (DP series).
NOTE
Use only the speci ed expression pedal (EV-5; sold
separately). By connecting any other expression pedals,
you risk causing malfunction and/or damage to the
unit.
Specifying the foot pedal assignment
Hold down the [SHIFT] button and press the [V-LINK]
button twice; the screen will indicate “
PDL
,” allowing you
to assign the e ect applied by the foot pedal.
You can assign the following functions to the pedal.
To save this setting, hold down the [SHIFT] button and
press the [WRITE] button.
Display Value Explanation
C01
CC01 ( MODULATION) Apply vibrato.
C05
CC05 ( PORTA TIME)
Control the portamento time over
which the pitch changes between
notes when playing with portamento.
C07
CC07 ( VOLUME) Control the volume.
C10
CC10 ( PAN) Control the panning.
C11
CC11 ( EXPRESSION) Control the expression.
C64
CC64 ( HOLD) Sustain the notes.
C65
CC65 ( PORTAMENTO)
Smoothly connect the pitch from one
note to the next.
C66
CC66 ( SOSTENUTO)
Sustain the notes that are currently
being held down.