Filter
Top Products
Response for tu - to - At - dE - Sn parameters:
‘OF’ - will respond to MIDI Controller data
‘On’ - will respond to MIDI Velocity data
Response for VL parameter:
‘OF’ - has a fixed MIDI Velocity level ( 100 )
‘On’ - will respond to MIDI Velocity data
Press the ‘CONT./VELOCITY’ button once and the display alternates between:
Typical Display Ident. Value
Use the ‘-’ and ‘+’ buttons to change the value. Press the ‘CONT./VELOCITY’ button again to select ‘to’ ( Tone ) ‘At’
( Attack ) etc. The display will loop back to ‘Tu’ ( tune ) after ‘VL’ ( Velocity ). Use the ‘Drum Select’ function again to change
these settings on another drum sound. This setting can be saved with the program.
NOTE: the ‘VL’ display ident. appears as a ‘UL’ on screen due to limitations of the 7 segment display.
Function 4 - Note-Off Recognition
This function is used to setup a drum sounds response to MIDI Note-Off messages. Normally, when a MIDI Note-On mes-
sage is received a drum sound will play in full ( long decay on a bass drum, cymbal etc.) thus ignoring any Note-Off mes-
sage. When set to recognised ( ‘rE’ ), the duration of the drum sound will be determined by the length of time a note is held
Utility Mode
Note Off Recogn’t’n
35
MIDI RX CH
MIDI TX CH
PROGRAM
EDIT WRITE
UTILITY
SAVE
MIDI RX CH
MIDI TX CH
PROGRAM
EDIT WRITE
UTILITY
SAVE