Filter
Top Products
9
Before You Begin Playing
Making the Connections
Connecting the
pedal cable
Insert the pedal cable into the Pedal connector on the rear panel of the
HPi-7.
Connecting the Speaker Cable
(HPi-7LE only)
1
As shown in the diagram, connect the speaker cable
leading from the speaker box of the stand to the speaker
connector located on the rear bottom of the HPi-7 LE.
Push the speaker cable in until it clicks into position.
* Do not put anything that contains water (e.g., flower vases) on this
unit. Also, avoid the use of insecticides, perfumes, alcohol, nail
polish, spray cans, etc., near the unit.
The speakers of this piano are mounted beneath the upper
surface, and face upwards. Malfunctions or accidents may occur if
liquids contact any part of the speakers.
Attach the
music rest
The music rest of the HPi-7 contains a liquid crystal display screen.
Use the following procedure, and handle the music rest with care.
1
Insert the music rest as shown in the diagram.
fig.mrest
2
Connect the cable of the music rest to the LCD Out
connector on the rear panel of the HPi-7.
* The power must be off when connecting the cable of the music
rest.
fig.LCDcord-e
Connect the
power cord
Insert the included power cord into the AC inlet on the bottom panel
of the HPi-7, and then plug it into an AC power outlet.
* Use only the included power cord.
fig.ACcord-e
Connect
headphones
1
Plug the headphones into the Phones jack on the bottom
panel of the HPi-7.
When you connect headphones, no sound will be output from the
internal speakers.
The headphone volume is adjusted by the [Volume] knob (p. 12)
of the HPi-7.
* Please use stereo headphones.
* Make sure to use only Roland headphones. Headphones from
other manufacturers may be unable to provide sufficient volume.
fig.headphones
Some Notes on Using Headphones
• To avoid damaging or severing the headphone cord, be
sure to handle the headphones by holding the phones
themselves, and grasping the plug and not the cord when
pulling the headphone plug.
• To prevent possible auditory damage, loss of hearing, or
damage to the headphones, the headphones should not be
used at an excessively high volume. Listen at appropriate
levels.
• The headphones may be damaged if the volume is too
high when they are plugged in. Connect the headphones
only after turning the volume down completely.
Speaker cable
Speaker connector
Clip portion
Speakers
Connecting Disconnecting
Bottom rear of the HPi-7
HPi-7_e.book 9 ページ ２００５年１月１８日 火曜日 午後４時３９分