Filter
Top Products
‘Menu’ parameters
VIMA JM-5
r
57
Utility
To edit the “Utility” parameters, you need to press the
[CURSOR÷VALUE] dial to open the “Utility” page.
The following table shows the “Utility” parameters.
Chord View Off, On Select “On” if chord
symbols of the chords
played by the selected
SMF song should be
displayed below the
lyrics. The chord sym-
bols only appear on
the external screen.
Parameter Value Explanation
SMF QuickStart Off, 2nd Bar,
1st Note
Off: Playback starts at
the very beginning of
the song file (which
may contain a few
silent bars).
2nd Bar: Causes play-
back to start from
measure 2 of the
selected Standard MIDI
File.
1st Note: This is basi-
cally the same as the
above, except that
playback starts on the
first note of the
selected song.
Playlist Next
Song
Off, On Specifies whether or
not playback of the
next song in playlist
should start automati-
cally. (Pressing the [ª]
button during playlist
playback automati-
cally selects the next
song.)
Music File
Channel
1~16 Allows you to specify
the MIDI channel of
the song file that con-
tains the harmony
data for the “Music
File” setting (see p. 26).
Rec Audio Level -24, -18, -12,
-6, + 0 dB
Allows you to set the
recording level for
your own perfor-
mances (see p. 30). The
setting of the
[MASTER VOL] knob
does not affect the
recording level.
Parameter Value Explanation
Rec Audio Sync Off, On Off: Choose this set-
ting when you want to
start recording before
starting song playback.
On: Choose this set-
ting when you want to
be able to start record-
ing simultaneously
with song playback.
When you choose this
setting, pressing the
[REC] or [ª] button will
stop both playback of
the song and the
recorder.
USB Driver Generic,
Original
Generic: Choose this if
you want to use the
standard USB driver
that was included with
your computer. Nor-
mally, you should use
this mode.
Original: Choose this
if you want to use a
USB driver down-
loaded from the
Roland website
(www.roland.com).
Audio In Level 0~127 Allows you to set the
input level of the sig-
nals received via the
INPUT (STEREO) socket.
See also page 15.
Audio In
Center Canc
Off, On Select “On” if the “Cen-
ter Cancel” function
(see p. 28) should also
affect the signals
received via the INPUT
(STEREO) socket.
Audio In
Transpose
Off, On Select “On” if the “Key”
function (see p. 29)
should also affect the
signals received via the
INPUT (STEREO) socket.
Auto Power Off Off, 240 min This parameter allows
you to cause the JM-5
to switch itself off
after 240 minutes if
you are not using it.
The default setting is
“Off”, meaning that the
JM-5 remains on until
you press the [POWER]
switch again.
Parameter Value Explanation
JM-5_US.book Page 57 Tuesday, December 14, 2010 10:29 AM