Filter
Top Products
17
Getting Ready
1.
Make sure that the [POWER] switch is off.
fig.power-onoff.eps
2.
Connect the included power cord to the included AC
adaptor.
3.
Connect the AC adaptor to the JUNO-Di’s DC IN jack, and
plug the power cord into an AC outlet.
fig.ACcord-e.eps_97
• Place the AC adaptor so the side with the indicator (see
illustration) faces upwards and the side with textual
information faces downwards.
• The indicator will light when you plug the AC adaptor into
an AC outlet.
• To prevent the inadvertent disruption of power to your unit
(should the plug be pulled out accidentally), and to avoid
applying undue stress to the DC IN jack, anchor the power
cord using the cord hook, as shown in the illustration.
fig.cordhook-e.eps
If eight commercially available AA nickel-metal hydride batteries are
installed, you’ll be able to play the JUNO-Di without connecting the AC
adaptor.
1.
While pressing the tabs of the battery compartment
cover on the JUNO-Di’s bottom panel, remove the cover.
fig.BattCase-1.eps
• When opening the battery compartment cover, make sure
that no foreign objects (flammable items, coins, pins, etc.) or
liquids (water, juice, etc.) enter the compartment.
• When turning the unit upside-down, get a bunch of
newspapers or magazines, and place them under the four
corners or at both ends to prevent damage to the buttons
and controls. Also, you should try to orient the unit so no
buttons or controls get damaged.
• When turning the unit upside-down, handle with care to
avoid dropping it, or allowing it to fall or tip over.
Connecting the AC Adaptor
Off
Upper position
AC Outlet
Indicator
DC Plug
AC Adaptor
(included)
AC Cord
DC IN
Cord Hook
The cord of
the supplied AC Adaptor
To the AC Adapter
DC IN Jac
k
Installing Batteries (Sold Separately)
Types of batteries that can be used
● Using nickel-metal hydride batteries will allow
approximately five hours of continuous operation at room
temperature. (However, the duration will be approximately
four hours if USB memory is connected. The duration of
continuous operation may differ depending on the
conditions of use.)
Do not use alkaline batteries or zinc-carbon batteries.
Battery handling
● If you connect the AC adaptor and turn on the power when
batteries are installed, the AC adaptor will be used
preferentially.
● If you’re using batteries, disconnect the AC adaptor from this
unit.
● If batteries are installed, disconnecting or reconnecting the
power cord at the AC outlet or disconnecting the DC plug
from the JUNO-Di’s rear panel while the power is on will cause
the power to turn off. You must turn off the power before you
connect or disconnect the power cord or AC adaptor.
● The BATTERY indicator is only an approximation.
● Avoid using new batteries together with used ones. In
addition, avoid mixing different types of batteries.
● Whenever the unit is to remain unused for an extended
period of time, save any important data on a USB memory,
and then remove the batteries.
● Improper handling of a battery, rechargeable battery, or
charger can cause leakage, overheating, fire, or bursting.
Before use, you must read all of the safety instructions for
your battery, rechargeable battery, and charger, and use
these items safely in accordance with the safety instructions.
● You must use the combination of rechargeable battery and
charger specified by the battery manufacturer.
JUNO-Di_e.book 17 ページ ２００９年６月２２日 月曜日 午前９時２３分