Filter
Top Products
21
Using the D1500 with the D2500
In order for the D1500 and D2500 to communicate with
each other it is necessary to configure the MIDI param-
eters so that the units are communicating properly. Follow
the steps below to configure the MIDI parameters for
communication between one D1500 RTA and one D2500
Digital EQ. Let's start with the D1500:
• Press the MIDI switch until you get to the “MIDI” screen
and use the DATA WHEEL to select “ON.”
NOTE: You may notice the MIDI light flashing which is indi-
cating that you are editing the MIDI set up.
• Now, press the MIDI again and set the MIDI CHANNEL
number to “1”.
• Press the MIDI switch once again and use the DATA
WHEEL to set the “OMNI” mode to “OFF”.
• Next, you need to configure the D1500 to transmit and
receive MIDI System Exclusive messages, so press the
MIDI switch again and use the DATA WHEEL to set the
SysEx to select “T+R”.
• Press the MIDI switch once again and use the DATA
WHEEL to set the “Pgm Ch.”(MIDI Program Change) to
“OFF”.
• Once you have all the parameters set, press the STORE
button to save the changes to the MIDI set up.
• Now, Let's set up the D2500.
• Press the D2500's Global switch a few times until the
display reads: F.R.
• Now,
turn the Data Wheel until the dispay reads +/-12
dB.
• Press the D2500's Global switch a few times until the
display reads: F.Bw.
• Then,
turn the Data Wheel until the display reads 1/3
Oct.
• Press STORE to confirm the Global changes.
• Press the MIDI switch until you get to the “MIDI”
screen and use the DATA WHEEL to select “ON.”
NOTE: You may notice the MIDI light flashing which is
indicating that you are editing the MIDI set up.
• Now, press the MIDI again and set the MIDI CHANNEL
number to “1”.
• Press the MIDI switch once again and use the DATA
WHEEL to set the “OMNI” mode to “OFF”.
• Next, you need to configure the D1500 to transmit and
receive MIDI System Exclusive messages, so press the
MIDI switch again and use the DATA WHEEL to set the
SysEx to select “T+R”.
• Press the MIDI switch once again and use the DATA
WHEEL to set the “Pgm Ch.”(MIDI Program Change) to
“OFF”.
• Once you have all the parameters set, press the STORE
button to save the changes to the MIDI set up.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES
CLASS B
. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MUST NOT CAUSE HARMFUL
INTERFERENCE
, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED INCLUDING INTERFERENCE THAT
MAY C
AUSE UNDESIRED OPERATION.
Operating the D2500 with the D1500 RTA
The diagram above shows the MIDI connections for using a D1500 RTA with a D2500
.