Filter
Top Products
22
Using the D1500’s EQ Display
The D1500 can be used to display the equalization curve
from 1, or up to 15, D2500 Digital Equalizers using the
standard MIDI or optional D-Net interface.
Before you get started using the EQ display feature, press
and hold the EQ switch for about two seconds and take
notice of the parameters that can be adjusted while using the
Generator. You’ll notice that the SOURCE and RES are illumi-
nated indicating that these parameters can be edited.
• Connect the MIDI OUT of the D1500 to the MIDI IN of
the D2500, and connect the MIDI OUT of the D2500 to
the MIDI IN of the D1500.
• Now, press the D1500’s EQ switch.
Operating the D2500 with the D1500 RTA
• Press RES and use the Data Wheel to select 2.0 dB,
which will correspond to the D2500 provided that the
Frequency Range (Global Menu) of the D2500 is set to
the default +/- 12 dB setting.
• Press the SOURCE switch and choose the MIDI channel
number that corresponds to the D2500 you want to
display on the D1500. Since the D2500 is a stereo equal-
izer there is a left and right selection for each equalizer
assigned to a MIDI channel, select CH 1L for the left side.
Note:
If MIDI OMNI ON is selected, the RTA will respond to the
D2500 that has most recently been changed.
• Now when you load in an EQ curve or move a fader on
the D2500 you will see the corresponding position of
each frequency band displayed on the D1500.
The diagram above shows a D1500 RTA displaying the fader positions of a D2500 digital equalizer.