Filter
Top Products
20
Rack Mounting Dual ULXP4 Receivers
Align the receivers side by side so that the front panels both face the same direction.
Place the supplied straddle bars in the recesses on the top and bottom of the receivers, so that the bars over-
lap both receivers. Refer to
Figure 50.
FIGURE 51
Secure the straddle bars to the receivers using the supplied screws. CAUTION: Do not overtighten the screws. Doing
so may damage the printed circuit boards.
Position the rack-mount brackets over the holes in the sides of each receiver, as shown in Figure 51.
Secure the brackets to the receivers with the supplied screws.
FIGURE 52
Slide the linked receivers into a 19-inch audio equipment rack, as shown in Figure 52.
Secure the brackets to the rack using all four of the supplied screws.
FIGURE 53
NOTE:
To front mount or combine antennas, use the optional accessories listed on page 24.
1.
2.
3.
4.
5.
6.
7.
1/4 IN.
1/4 IN.