Filter
Top Products
6
SINGLE SYSTEM SETUP
Receiver Connections
NOTE: If you are installing multiple ULXP4 Professional systems, or systems with multiple ULXP4 receivers,
refer also to the Advanced Programming section of this manual.
1. Plug the dc power supply into the power connector on the back of the receiver, as shown in Figure 4. Connect the
other end of the power supply into an electrical outlet.
FIGURE 4
2.
Attach the two antennas to the ANTENNA connectors, as shown in Figure 5. The ULXS4 is supplied with 1/4 wave
antennas; the ULXP4 is supplied with 1/2 wave antennas.
FIGURE 5
3.
Connect audio cable(s) (not supplied) from the audio output(s) to the audio input(s) of your audio system, mixer and/
or amplier, as shown in Figure 6.
F
IGURE 6
ULXS4
ULXP4
ULXP4
ULXS4