Tascam DP-02CF Musical Instrument User Manual


 
IMPORTANT SAFETY INSTRUCTIONS
TASCAM DP-02/DP-02CF 51
2 – Advanced techniques
This copies a track or pair of tracks to another track or pair
of tracks.
There are no IN and OUT points when cloning.
There are two values that you can change:
SOURCE.TRK Select an individual track (1 through 8),
a pair of tracks (1/2, 3/4, 5/6, 7/8) or the MASTER stereo
track.
DESTINATION. TRK This sets the destination track or
tracks to which the source track is cloned. What you can
select here depends on what you have selected for the source
track. If you have selected a single track, you can select
tracks 1 through 8 here. If you have selected a pair of tracks
(for instance, 1/2), you can only select track pairs here.
Press YES/ENTER to perform the operation or NO/EXIT to
leave this screen.
NOTE
If you try to select the same track as a destination that
you have selected as the source, when you press the
YES key, a message will appear.
T I P
Although you cannot mix the inputs of the STEREO MIX
to the mixed master track, you can add a drum machine
(say for instance) to the mix in the following way:
Mix down to the mix master track, using the EFFECT
SEND and EFFECT RETURN (“Mixdown and master-
ing” on page 27) to add reverb to your mix.
Clone the stereo mix to a pair of tracks.
CLONE TRACK
This function deletes the material between the IN and OUT
points on the chosen track or tracks and “closes up” the
gap.
The source and destination are the same, and after the
operation, the material between the IN and OUT points is
deleted. The track is therefore shorter than the original.
OUTIN
IN
There is only one value that you can change:
CUT.TRK Select an individual track (1 through 8), a pair
of tracks (1/2, 3/4, 5/6, 7/8), all of the tracks (1-8) or all
tracks (ALL).
Press YES/ENTER to perform the operation or NO/EXIT to
leave this screen.
CUT
This function is equivalent to recording silence between
the
IN
and
OUT
points on the chosen track or tracks.
Material is deleted, but the length of the result is the same
as that of the original (the gap is not closed up, unlike with
the CUT function).
OUT
OUT
IN
IN
There is only one value that you can change:
SILENCE.TRK
Select an individual track (1 through 8), a
pair of tracks (1/2, 3/4, 5/6, 7/8), or all the tracks (1-8).
Press
YES/ENTER
to perform the operation or
NO/EXIT
to
leave this screen.
SILENCE