Filter
Top Products
5 – Control Panel
28 TASCAM FW-1082 Owner’s Manual
CoreAudio tab (OS X only)
In OS X, you can specify how the FW-1082 should
appear to the operating system:
The options available are as follows:
10-input/4-output All analog input channels are
used, and the analog monitor outputs are enabled.
The S/PDIF input channels become channels 9 and
10, and the S/PDIF output channels become two
additional output channels.
4-input/4-output Select either the first four ana-
log input channels (with the integrated mic pre-amps)
or the first two analog channels and the S/PDIF input
channels as inputs.
The outputs are the analog monitor outputs and the
digital S/PDIF digital output pair.
2-input/2-output Select a pair (1-2, 3-4 etc.) of
analog inputs or the digital S/PDIF inputs as the
input pair.
Select either the analog outputs, or the S/PDIF digital
outputs as the output pair.
TIP
In order to optimize the load on your CPU, you should
configure the FW-1082 for your situation. If you are
making a live stereo recording using the FW-1082, there
is little point in configuring a 10-in/4-out device, for
example.
Figure 5.3: Core Audio tab for OS X