Filter
Top Products
TYPICAL SETUPS
15
In project studios you may enjoy utilizing some of the
effects in G-Natural while recording. In this setup we
show a setup with a condenser microphone connected to
G-Natural and G-Natural’s L/R outputs directly to and
audio interface.
Connections
• Connect the condenser mic to the G-Natural's mic
input
• Activate phantom power
• Connect L/R outputs to your audio interface (or use
the digital output)
WARNING! When connecting the G-Natural
outputs to microphone inputs on a mixing console,
the phantom power for these channels MUST be
switched off! Otherwise you may damage the
G-Natural circuits.
Basic settings
• Set input sensitivity via the Levels menu
• Select active effect pressing the COMP, MOD,
DELAY and REVERB switches
• G-Natural feature separate EQ and compression
settings for mic and instrument inputs
G-Natural in a studio
algorithm select
mod delay
menu
subdivcomp EQ boost reverb
BANK UP
BANK DN
COMP
123
MOD DELAY
BOOST
/TAP TEMPO
REVERB
store levels
G•NATURAL
factory
default
4321
VARIATIONS
holdto save
boost flanger plate p.pongstomp
EQ
chorus room reverse
dynam
tapevibrato
analogdetune
cleanthicken
studio
tremolo
hall
spring
3
3
+
+
+
Decay PreDly Color MixMM
1.2s 250ms 100% 25%
edit A edit B edit C edit D
presetbank | tune
Instrument
input
Microphone input
LRoutputs
ch1/2
rear
on
panel
phan
+48V
ch1/2
phan linein
muting
non
muting
ch.select
push pan/userpushpan/userpush pan/user
+48V ch1/2on
ch1/2
rear panel
ch1 ch2 3/4user
mic|inst ch1 mic|inst ch2
monitor
phones
gain trim
gain trim
source level output level
made by
maxmin
maxmin
dsp total recall
P1P2P3
select
maxmin
-30-30 -10-10 O/LO/L
pad|inst pad|inst
Audio inteface