Filter
Top Products
3.
Turn on the transmitterby sliding the powerswitch to itson po
-
sition. Check the condition of the battery by watching the light
below the power switch. The red battery light should flash once
and then go out. If the light stays on, the battery is weak and
should be replaced.
4.
Verify reception. When the transmitter is turned on: (FMR-10)
the RF meter will illuminate, indicating that the receiver is pick-
ing up the signal. If thisdoes nothappen, make sure that thetrans-
mitter and receiver are set to the same channels.
5.
Connect the audio source. If using a lavalier or headworn mi-
crophone, insert the connector on the end of the mic wire, into the
connector on the bodypack. If using a lavalier mic, use the clip to
attach the mic to the users clothing. If using the headworn mic,
place the headset on the user’s head, positioning the mic at the
corner of their mouth.
Note: Keep the audio muted while plugging in and adjusting
the microphone or source. Placement of lavalier and headworn
microphones will noticeably change the sound quality, so some
testing with the user is necessary. An important point to remember,
the closer to the sound source, the stronger or louder the signal.
6.
Unmute the audio, by sliding the large AUDIO switch located on
the bodypack, to the ON position.Speak or sing into themicrophone
and you should hear your voice through the PA / sound system.
7. Listen carefully to the audio andbe sensitiveof overloaddistor
-
tion and low gain.
-14-
POWER
O
POWER
SWITCH
AUDIO
SWITCH
MIC
CABLE
ENTRY
BATTERY LIGHT
N
BAT.
O
F
F
AUDIO
ANTENNA
Figure 12