Telex FMR-10 Microphone User Manual


 
8.
Adjust the transmit gain if necessary. Gently insert the pro
-
vided screwdriver or other 3/32-in. 2.4mm screwdriver into the
gain adjustment located at the top edge of the battery compart
-
ment under the door (see Figure 11). The door has to be opened
but notswung upward to make adjustments. Turnlightly until the
screwdriver tip drops into the sloton the level control. Gently turn
the control counterclockwise until the control stops (the audio
output is attenuated but not “off”). Slowly turn the audio level
control clockwise while listening to audio; if the audio becomes
distorted, turn the mic level control counter-clockwise about 1/8
turn.
9.
Test performance. Check to see that the RF meter on the
FMR-10 receiver is illuminated, an indication that the receiver is
picking up the signal. Then, “walk” the intended area of use and
make sure that there are no barriers to reception or sources of in-
terference. If problems are encountered, see Troubleshooting
Guide.
10.
Clip the bodypack to the user’s belt or pocket. The bodypack
can be positioned horizontally or vertically by moving the belt
clip attachment. This is done by removingthe belt clip attachment
screw, rotating the clip to the desired position, and replacing the
screw.
-15-