Filter
Top Products
VIZIO VHT510 User Manual
Version 5/25/2010 21
www.VIZIO.com
VHT510 Specifications
Sound Pressure Level
Sound Bar: 100 dB SPL
Subwoofer: 95 dB SPL
Power Input
AC Power Brick with 6' power cable for Sound Bar
Integrated Power Supply on Subwoofer with 6' power cable
Voltage
100-240VAC, 50-60Hz
Dimensions Sound Bar
w/stand
39.86” W x 4.63” H x 4.25” D (1012mm x 117mm x 108mm)
Dimensions Sound Bar
w/out stand
39.86” W x 3.75” H x 4.25” D (1012mm x 95mm x 108mm)
Dimensions Subwoofer
11.25” W x 13” H x 11.86” D (286mm x 330mm x 301mm)
Dimensions Satellite
Speakers
2.86” x 7.5” x 11.86” (73mm x 190mm x 102mm)
Net Weight Sound Bar
w/stand
7.8 lbs (3.5Kg)
Net Weight Sound Bar
w/out stand
7.4 lbs (3.4Kg)
Net Weight Subwoofer
14.6 lbs (6.6Kg)
Net Weight Satellite
Speaker
2.2 lbs (1Kg)
Gross Weight
32 lbs (14.5Kg)
Compliances
UL, CSA, VDE, BASE/BS, and Electric Appliance Control Act
*Product specifications may change without notice or obligation
FCC Class B Radio Interference Statement
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy, and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Notice:
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
Shielded interface cables and AC power cord, if any, must be used in order to comply with the emission
limits.
The manufacturer is not responsible for any radio or TV interference caused by unauthorized modification
to this equipment. It is the responsibility of the user to correct such interference.