Filter
Top Products
9
Connecting to a 2-Channel Stereo Receiver/Mixer/TV
When connecting to the 2-channel L/R audio inputs on a stereo receiver or TV, the DVG-909K gives you the option of
outputting both disc players independently or together through the Mixed audio output.
Connecting each disc player independently (Fig. A)
Connect your L/R RCA cables to the L and R AUDIO outputs on the rear panel of the DVG-909K to the L/R (red and wh
ite)
audio inputs on your 2-channel stereo receiver, mixer or TV. See figure. A
NOTE: Depending on the stereo receiver/TV, the audio input jacks may be labeled AUDIO, LINE, AUX, AV 1, etc.
Connect the disc players together using the Switched Output (Fig. B)
Connect your L/R RCA cables to the L and R MIX AUDIO OUT on the rear panel of the DVG-909K. Connect the other end
of your cables to the L/R (red and white) audio inputs on your 2-channel stereo receiver, mixer or TV. See figure. B
NOTE: When using the Switched Output, the DVG-909K will automatically switch the audio output to the active disc player
A or B.
Getting connected cont.
Connecting to a DTS Receiver/Decoder (Fig. C)
Using either an RCA-ended COAXIAL cable suited for digital audio or an OPTICAL cable, connect one end to the appropri
-
ate jack on the DVG-909K (Coaxial or Optical) and the other end to the appropriate jack on the DTS receiver (Coaxial or
Optical).
NOTE: If you have both coaxial and optical inputs on your DTS decoder/receiver, it is recommended that you use an optical
connection as those cables eliminate the possibility of EMI (electromagnetic interference). If your DTS receiver does not
have a built-in DTS decoder, and has 5.1 channel RCA inputs, you can use the 5.1 channel output jacks on the DVG-909K.
Either method will provide for DTS decoding.
B
KJ-7800 PRO
DTX-5000G
LTV-5
(Fig. A) (Fig. B) (Fig. C)
2-Channel/DTS