Filter
Top Products
12
1. LED METERS - These meters display system
OUTPUT LEVELS. For maximum performance with
a clean, undistorted signal, increase source output,
as well as the KJ-7808RV’s GAIN, CHANNEL FADER
and L/R MASTER FADERS until meter peaks in the
yellow LED range (-2 to +4). Input should rarely
cause meters to peak in the range of the red LEDs
for best sound.
2.
12V LIGHT JACK (BNC) - This BNC style jack is
for connecting a 12V DJ LIGHT, ideal for mixing in
dark environments.
3. POWER - This button turns the KJ-7000 Pro ON
in the upper position, OFF in lower.
4. AV OUT LEVEL - This level control only affects
the RCA jacks from AV OUT on the back panel.
MASTER and CHANNEL faders will not effect ouput
levels from these jacks.
5. HEADPHONES jack - This 1/4” jack is for
connecting HEADPHONES.
6. MASTER EQUALIZER - This 5-band, Graphic EQ
gives you additional control over your tone in the
60 Hz, 250 Hz, 1KHz, 4Khz and 12KHz frequencies
with a +/- 12 boost or cut for precise room
tuning. Adjust these controls to suit your sound
quality preferences.
7. MASTER EQUALIZER ON/OFF - This button
must be pressed in to activate the Graphic EQ.
8. CUE/MASTER - This button toggles between CHANNEL Cueing and MASTER Cueing. When CHANNEL cueing,
you will only hear channels that have been selected for Cueing. When MASTER Cueing, you will hear MASTER
OUTPUT, regardless of which channels have been selected for Cueing. Note: Digital Key Control changes are
only audible when MASTER Cueing.
9. MASTER L/R FADERS - These slide controls raise and lower the Left and Right MASTER OUTPUT levels for
all stereo channels as they are moved up and down, providing an overall volume level for each channel mixed
together. Balance each channel’s individual fader control for the best mix.
10. BOOTH FADER - This slide control raises or lowers the output level for the BOOTH OUT
located on the back panel.
Note: This slide control is only functional when monitors or a
control booth is connected from the corresponding outputs.