18
EMX2000—Owner’s Manual
■ Input specifications
■ Output specifications
Specifications are subject to change without prior notice.
1. Sensitivity is the lowest level that can produce an output of +4 dB (1.23 V) or the nominal output level when the unit is set at maximum gain.
2. XLR type connectors and PHONE JACKS (TRS) (T=HOT, R=COLD, S=GND) are balanced.
3. PHONE JACKS are unbalanced.
• In these specifications when dB represents a specific voltage, 0 dB is referenced to 0.775 Vrms, 0 dBV is referenced to 1 Vrms.
1. PHONE JACKS are balaned.
• In these specifications when dB represents a specific voltage, 0 dB is referenced to 0.775 Vrms, 0 dBV is referenced 1 Vrms.
Input terminals
Gain
trim
Actual load
impedance
For use with
nominal
Input level
Connectors on mixer
Sensitivity
1
Max. before clip
MIC INPUT
(1–8)
MAX
MIN
5 kΩ 50~600Ω Mics
–60 dB (775 µV)
–16 dB (123 mV)
–40 dB (7.75 mV)
+4 dB (1.23 V)
XLR-3-31 type
2
LINE INPUT
(1–8)
MAX
MIN
50 kΩ 600Ω Lines
–34 dB (15.5 mV)
+10 dB (2.45 V)
–14 dB (155 mV)
+30 dB (24.5 V)
PHONE JACK (TRS)
2
ST INPUT
(9–12)
MAX
MIN
10 kΩ 600Ω Lines
–34 dB (15.5 mV)
+10 dB (2.45 V)
–14 dB (155 mV)
+30 dB (24.5 V)
PHONE JACK
3
ST SUB IN (1, 2) 10 kΩ 600Ω Lines +4 dB (1.23 V) +20 dB (7.75 V)
TAPE IN (L, R) 10 kΩ 600Ω Lines –10 dBV (316 mV) +10 dBV (3.16 V) PHONO JACK
CH INSERT IN (1–4) 10 kΩ 600Ω Lines 0 dB (775 mV) +20 dB (7.75 V)
PHONE JACK (I/O)
3
POWER AMP IN (L, R) 10 kΩ 600Ω Lines +4 dB (1.23 V) +18 dB (6.16 V)
PHONE JACK
3
Output terminal
Actual source
impedance
For use with
nominal
Output level
Connectors on
mixer
Nominal Max. before cliping
ST OUT 1, 2 (L/R) 75Ω 600Ω Lines +4 dB (1.23 V) +20 dB (7.75 V)
PHONE JACK
1
MONO OUT 75Ω 600Ω Lines +4 dB (1.23 V) +20 dB (7.75 V)
EFFECT SEND 75Ω 600Ω Lines +4 dB (1.23 V) +20 dB (7.75 V)
MONITOR OUT 1, 2 75Ω 600Ω Lines +4 dB (1.23 V) +20 dB (7.75 V)
REC OUT (L/R) 600Ω 10 kΩ Lines –10 dBV (316 mV) +10 dBV (3.16 V) PHONO JACK
CH INSERT OUT (1–4) 600Ω 10 kΩ Lines 0 dB (775 mV) +20 dB (7.75 V)
PHONE JACK
1
PHONES/
C. R. OUT
for PHONES
100Ω
40Ω Phones 3 mW 100 mW
ST PHONE JACK
1
for C. R. OUT 10 kΩ Lines +4 dB (1.23 V) +20 dB (7.75 V)
SPEAKER OUT 1, 2 (L/R) 0.1Ω 4/8Ω Speaker 200 W/4Ω 200 W/4Ω
PHONE JACK
1
BRIDGE OUT 0.1Ω 8Ω Speaker 400 W/8Ω 400 W/8Ω