Filter
Top Products
6
EMX2000—Owner’s Manual
■
Master control section
In this section, you can adjust the final level of
the outputs.
E
MONI 1 (monitor 1) fader
The MONI 1 fader adjusts the final level of the
signal sent from the MONITOR 1 bus to the
MONI 1 jack (input/output panel
9
). If the
Power amp select switch
V
is set to MONI 1-
MONO, using this fader enables you to adjust the
level of the signal sent from the SPEAKER L 1/2
jacks to the speakers.
F
MONI 2 (monitor 2) fader
The MONI 2 fader adjusts the final level of the
signal output from the MONITOR 2 bus to the
MONI 2 jack (input/output panel
9
).
G
EFFECT fader
The EFFECT fader adjusts the final level of the
signal output from the EFFECT bus to the
EFFECT jack (input/output panel
A
).
H
ST 1 (stereo 1) fader
The ST 1 fader adjusts the final level of the signal
sent from the STEREO bus to the ST 1 jacks
(input/output panel
8
). If the Power amp select
switch
V
is set to ST L-ST R, this fader also
adjusts the level of the signal sent to the SPEAK-
ERS jacks (rear panel
1
).
I
MONO (monaural) fader
The MONO fader adjusts the final level of the
monaural signal output from the STEREO bus to
the MONO jack (input/output panel
0
).
If the Power amp select switch
V
is set to
MONI 1-MONO, this fader also adjusts the level
of the signal sent from the SPEAKERS R 1/2 jacks
to the speakers.
If the Power amp select switch
V
is set to MONO
BRIDGE, this fader adjusts the level of the signal
sent from the SPEAKERS BRIDGE jack to the
speaker.
J
AFL (after fader listen)
When this switch is on, the output signal that
passes through the corresponding fader is sent to
the PHONES/C-R OUT jack (input/output panel
B
). Use these switches when you wish to moni-
tor a particular output signal through the head-
phones.
■
Tape in section
In this section, you can adjust the input level of a
cassette deck or a CD player that is connected to
the TAPE jacks (input/output panel
5
).
K
ST (stereo) control
This knob adjusts the level of the signal sent from
the TAPE jacks to the STEREO bus.
L
PFL (pre-fader listen) switch
When this switch is on, the signal input from the
TAPE jacks is routed at the point before the ST
control to the PHONES/C-R OUT jack (input/
output panel B).
Note: The setting of this fader does not affect
the level of the signal sent from the EFFECT
bus to the built-in effect.
Note: The setting of this fader does not affect
the signal output from the STEREO bus to the
ST 2 jacks.
AFL AFLAFLAFLAFL
0
5
10
15
20
25
30
40
50
∞
0
5
10
15
20
25
30
40
50
∞
0
5
10
15
20
25
30
40
50
∞
0
5
10
15
20
25
30
40
50
∞
0
5
10
15
20
25
30
40
50
∞
MONI 1 MONOST 1EFFECTMONI 2
E F G H I
J
TAPE IN
100
ST
PFL
K
L