Filter
Top Products
Control Templates
Owner’s Manual
29
Editing a Control Template
Changing the message type
generated by using the CONTROL
knobs
The MIDI messages generated by operating the
CONTROL knobs are divided into two types:
Remote and CC (Control Change). Only one of
these two types can be active, and the type is set
with the KnobOutSel parameter.
Remote (Remote Control message dedicated to
Cubase)
When this is selected, Remote Control messages
dedicated to Cubase will be generated by
operating the CONTROL knobs and transmitted to
Cubase via USB-MIDI Port 2. This type of data is
transmitted via USB-MIDI Port 2, while keyboard
performance data is transmitted via USB-MIDI Port
1, meaning that the messages generated by
operating the CONTROL knobs do not affect the
keyboard performance but only the VSTi
parameters.
CC (Control Change)
When this is selected, Control Change messages
will be generated by operating the CONTROL
knobs and transmitted to the computer via USB-
MIDI Port 1. When using a DAW other than Cubase,
only this setting is available.
1.
Press the [CONTROL TEMPLATE] button.
The LED lamp lights and the Control Template
selection display appears.
2.
Use the DATA [DEC] and [INC] buttons to
select the desired Control Template.
3.
Use the SELECT [▲] and [▼] buttons to call
up “KnobOutSel.”
4.
Use the DATA [DEC] and [INC] buttons to
select the desired type of message.
CC ...................... Control change
Remote ............... Remote Control exclusive for
Cubase
5.
Press the [EXIT] button to return to the
original display.
NOTE
· When using Cubase, you generally won’t
need to change this parameter from the
initial default setting (Remote), although
there may be times that you should set
this parameter to “CC” depending on the
VSTi you’re using.
· Setting the DAW Select parameter to a
value other than “Cubase4” or “CubaseAI”
will change the KnobOutSel parameter to
“CC” automatically even when it is set to
“Remote.”
NOTE
If a different, unrelated display appears even
when you press the [CONTROL
TEMPLATE] button, press the [CONTROL
TEMPLATE] button again or press the
SELECT [▲] button once or twice to call up
the Control Template selection display.