Filter
Top Products
Storing/Saving Data
68 MM6/MM8 Owner’s Manual
A new USB storage device must be formatted before it can be used by this instrument.
1
After connecting the USB storage
device to be formatted to the instru-
ment’s USB TO DEVICE terminal, check
that “CONNECT” is showing in the
MAIN display.
2
Press the [MENU] button.
A message will appear asking you to confirm
the format operation.
3
Press [EXECUTE] button and a confir-
mation message will appear.
You can press the [DEC/NO] button at this
point to cancel the operation.
4
Press the [EXECUTE] button again, or
the [INC/YES] button, and the format
operation will begin.
5
A message will appear on the display
when the operation is complete.
Press the [EXIT] button to return to the MAIN
display.
Formatting a USB storage device
• If you format a USB storage device that already contains data, all
of the data will be erased. Be careful not to erase important data
when using the format function.
CAUTION
• If the Load item appears in step 2, press the CATEGORY [INC] /
[DEC] buttons as many times as necessary until the Format item
appears.
NOTE
• Once the format-in-progress message appears on the display
the format operation cannot be canceled. Never turn off the
power or remove the USB storage device during this operation.
CAUTION
• If the USB storage device has been write-protected, an appropriate
message will appear on the display and you will not be able to exe-
cute the operation.
NOTE