Filter
Top Products
MM6/MM8 Owner’s Manual 83
Messages
LCD Message Comment
Access error! Indicates the failure in reading or writing from/to the media or the flash memory.
All Memory Clearing...
Displayed while erasing all data in the flash memory.
Never turn the power off during data transmission.
Are you sure? Confirms whether Song Clear or Track Clear is executed or not.
Backup Clearing... Displayed while clearing the back-up data in the flash memory.
Cancel Displayed when the transmission of Initial Send is cancelled.
Clearing... Displayed while executing Song Clear or Track Clear for a user song.
Completed Indicates the completion of the specified job, such as saving data or transmission.
Data Error! Displayed when the user song contains illegal data.
End Displayed when transmission of Initial Setup data has been completed.
Error! Displayed when a write operation has failed.
File information area is not large enough.
Indicates that data cannot be saved to the media because the total number of files
is too large.
File is not found. Indicates that there is no file.
File too large. Loading is impossible. Indicates that data cannot be loaded because the file is too large.
Format OK ? [EXECUTE] Confirms whether the media format operation is executed or not.
Formatting... Displayed while formatting.
Load OK ? Confirms whether loading is executed or not.
Loading... Displayed while loading data.
Media is not inserted.
This message will appear if you attempt to access a memory device when no mem-
ory device is connected to the USB TO DEVICE terminal.
Media capacity is full. Displayed when data cannot be saved because the memory media is full.
Memory Full Displayed when the internal memory becomes full during song recording.
MIDI receive buffer overflow. Displayed when the MIDI receive buffers overflows.
Now Writing...
(Don’t turn off the power now, otherwise
the data may be damaged.)
Displayed while writing data to the memory. Never turn the power off while writing.
Doing so may result in data loss.
Overwrite ? Confirms whether overwriting is executed or not
Save OK ? Confirms whether saving is executed or not
Saved data is not found. Displayed when the data to be saved doesn’t exist.
Saving...
Displayed while saving data to the memory. Never turn the power off while saving.
Doing so may result in data loss.
Send OK? Confirms whether the data transmission is executed or not
Sending... Displayed while transmitting data.
Since the media is in use now, this
function is not available.
Indicates that the file control function is currently unavailable since the media is
being accessed.
Sure ? [YES/NO] Reconfirms whether each operation is executed or not
The limit of the media has been reached.
Indicates that data cannot be saved because the folder/directory structure has
become too complicated.
The media is not formatted. Indicates that the inserted media has not been formatted.
The media is write-protected.
Indicates that the inserted media cannot be written to because it is write-protected.
Set the write-protect switch to the “overwrite” position before use.
There are too many files.
Indicates that data cannot be saved because the total number of files exceeds the
maximum capacity.
This function is not available now.
Indicates that the designated function is not available because the instrument is
executing another job.
• Not all messages are listed in the table.
NOTE