Filter
Top Products
MV12/6 — Owner’s Manual
Front & Rear Panels 9
!1 MONO OUT Jack
This signal is the monaural mix of the STEREO bus’s stereo signal. Its level is controlled with the
MONO control.
Two types of jacks are provided; balanced XLR type and Euro-block connectors.
• XLR type (1: Ground, 2: Hot, 3: Cold)
Nominal output/impedance +4dB/600Ω
• Euro-block connector (
: Hot, : Cold, G: Ground)
Nominal output/impedance +4dB/600Ω
!2 MONITOR (L, R) Jacks
This is an unbalanced Euro-block connector output jack for connecting a monitor system, etc. with a
nominal output/impedance of +4dB/10kΩ.
Use the PHONES/MONITOR output and meter select switch (Master Control Section) to select the
source to be monitored.
!3 POWER Switch
When the switch is in the ON position, the unit is powered.
When turning the power ON, first turn on the mixing console, then turn on the power amp or powered
speakers that are connected to the mixer.
Also, when turning the power OFF, turn off the power amp or powered speakers before turning off the
mixing console.
Connector polarity
INPUT, ST OUT, MONO OUT
Pin 1: ground
Pin 2: hot (+)
Pin 3: cold (–)
INSERT IN, INSERT OUT,
GROUP OUT,
AUX 1/AUX 2/EFFECT SEND
Tip: hot (+)
Ring: cold (–)
Sleeve: ground
PHONES
Tip: L
Ring: R
Sleeve: ground
RETURN
TipSleeve
Ring
TipSleeve
Tip: hot
Sleeve: ground
INPUT OUTPUT