Filter
Top Products
MV12/6 — Owner’s Manual
ST OUT
AUX 1
SEND
AUX 2 (PRE)
SEND
PHONES
TAPE IN
REC OUT
INPUT
GROUP OUT
1
2
3
4
Applications 13
Example 2) Banquet Room Setup Using Independent
Speakers
Procedure
q Connect line input devices or microphones to the INPUT jacks and connect a power amp, that is
connected to the main speakers, to the ST OUT Jacks. Also, connect a 4CH Power Amplifier, etc. that
drives the side speakers to the GROUP OUT (1-4) Jacks.
w Use the GAIN Control on each channel to adjust the level of the input signal from the device or
microphone that is connected to the input channel (refer to page 3), and use the Channel Fader to
adjust the level of the output signal that is sent to the Master Section. Basically, you should set the
Channel Fader close to the “0” position.
e Press the “ST”, “1-2”, “3-4” GROUP, ST Select Switches on each channel.
r Use the ST Master Fader and the GROUP 1-4 Faders to adjust each signal’s output level that is sent to
the power amp. The fader’s “0” position is an average level.
t Use the volume control on the power amp to adjust the speaker’s volume.
If it is necessary, use monitor devices (a pair of headphones, monitor speaker, etc.) or recording devices.
Microphone, Line Input
GROUP 1-4 Faders
Main Speakers
ST Master Fader
PHONES/MONITOR Output and
Meter Select Switch
Monitor Speakers
Headphones
Set the POST Switch to “?” (AUX2=PRE).
GROUP, ST Select Switches
Channel Faders
Power Amplifier
4CH Power
Amplifier, etc.
CD recorder, tape deck, etc.
Power Amplifier
Side Speakers
13
Side Speakers
Side Speakers
24
Main Speaker
L
Main Speaker
R
Monitor Speakers