Filter
Top Products
Using USB Flash Memory
PSR-S500 Owner’s Manual 75
A new USB flash memory device must be formatted before it can be used by this instrument.
1
After connecting the USB flash memory
to be formatted to the instrument’s USB
TO DEVICE terminal, check that the
“CONNECT” message is shown in the
MAIN display.
2
Press the FILE MENU [MENU] button.
3
Use the CATEGORY [ ] and [ ] but-
tons to select the Format item.
The display prompts you for confirmation.
4
Press the [EXECUTE] button and the
display prompts you for confirmation.
You can press the [-/NO] button at this point to
cancel the operation.
5
Press the [EXECUTE] button again, or
the [+/YES] button, and the format oper-
ation will begin.
6
A message appears in the display indi-
cating that the operation is complete.
Press the [EXIT] button to return to the MAIN
display.
Formatting USB Flash Memory
• If you format a USB flash memory that already contains data, all of
the data will be erased. Be careful not to erase important data
when using the format function.
CAUTION
f
r
• Once the format-in-progress message appears in the display,
the format operation cannot be canceled. Never turn off the
power or remove the USB flash memory device during this
operation.
CAUTION
• If the USB flash memory device has been write-protected, an appro-
priate message will appear in the display and you will not be able to
execute the operation.
NOTE