Filter
Top Products
156 Chapter 2. SONG MODE
1. Source track
• The first TR setting selects the track from which events are
to be extracted.
0101
1101
01,...,32
2. Source segment
• The two boxes to the right of the M select the track segment
for the extraction.
0101
1101
Measure: beat 001:1,...,999:8
3. Spot clock
• The Spot Clock parameter selects the interval of each meas-
ure from which data are to be extracted.
• The interval is set by clock cycles, where each measure starts
at cycle 0000. There are 480 cycles per quarter note.
• For example, assume that timing is set to 4/4. In this
case, if you want to extract data only from the first half
of each measure, you would set the range to 0000 – 0959.
If you wanted to copy only those events that fall exactly
on the fourth beat, you would set the range to 1440 –
1440.
0101
1101
0000,...,3840
4. Destination track
• The lower TR setting selects the destination track.
0101
1101
01,...,32, Off
• 01,...,32 Sequence track
• Off No destination. (Extract and delete)
5. Event
• The third pair of boxes (at the center of the screen) select
the event type to be extracted.
0101
1101
Note, PC, PB, CC (000,...,127, All), CAT, PAT, EXC
• Note Note events (C2,...,G8, All)
•PC Program change
•PB Pitch bend
• CC(000,...,127,All) Control change (Any single control-
change message type 000 to 127, or
all control-change messages)
•CAT Channel aftertouch
•PAT Polyphonic aftertouch
• EXC System exclusive
6. Argument range
• The lowest two boxes on the screen select the argument
range. The QY700 will extract only those note events whose
arguments fall within the specified range.
• If you are extracting note events, for example, you can use
this setting to limit extraction to all note events within a
certain pitch range (for example, C3 to C4). If extracting
program-change events, you can limit extraction to events
with a certain range of program numbers only.
• Note that the EXC event type does not accept an argument-
range value.
• The values listed below show the maximum ranges. In all
cases you can set a smaller range. Note that the first value
of the range must be less than or equal to the second value.
0101
1101
C-2,...,G8 Maximum range for note events
-8192,...,+8191 Maximum range for pitchbend events
000,..,127 Maximum range for all event types other than
note and pitchbend.
7. Song Jobs
0000 0480 0960 1440 1919
4/4
0000 04800240 09600720 1200 1439
6/8