Filter
Top Products
245Chapter 5. PATTERN MODE
5
4. Pattern Effects
Shows name and value of cursor-selected parameter.
Selects the effect type.
Various parameter values for the selected effect.
Sets balance between wet sound (sound passed through varia-
tion effect) and dry (non-effected) sound. Setting appears only if
variation mode is set to Insertion.
Appears beside parameter that can be controlled with AC1 (As-
signable Controller 1).
Sets AC1 control depth for the controllable parameter.
View only
D63>W,...,D=W,...,D<W63
View only
-64,...,+0,...,+63
Parameter Values Function See page
P.245
P.245
P.245
P.245
P.245
P.246
1 Data display
2 Effect type
3 Effect parameters
4 Dry/wet balance
(On Variation Edit page, if mode = Insertion)
5 Controllable parameter
(On Variation Edit page, if mode = Insertion)
6 AC1 control depth
(On Variation Edit page, if mode = Insertion)
• These three pages set the various parameters for the reverb
effect, chorus effect, and variation effect.
1. At the PATCH screen, press 3 (Effect).
▼ The QY700 enters the Pattern Effects submode.
2. Press 2 (Reverb), 3 (Chorus), or 4
(Vari.) to move to the editing page for the effect that
you need to edit.
3. Move the cursor to the parameters you need to set,
and enter the values using the data dial, n/y, or
the numeric keypad.
4. When you are ready to return to the main PATCH
screen, press e.
• The playback keys (p, s, t, r/f) continue to
function while you are adjusting the settings, so that you
can monitor the results of your changes as you make them.
1. Data display
• The data-display area shows the name and current value of
the parameter selected by the cursor.
2. Effect type
• This parameter selects the effect type. Note that you can
also view or change these values at the Effect Connection
Setup screen. (→ p.241)
• If the variation mode is Insertion and the variation effect
type is NO EFFECT, the QY700 will not produce any sound
at all for the part whose variation switch is turned ON.
3. Effect parameters
• These values adjust the operation of the selected effect type.
Available parameters vary according to the type.
4. Dry/wet balance
(Only on Variation Edit page; only if mode is Insertion)
• This parameter sets the balance between the wet sound (the
sound that receives the variation effect) and the dry sound
(the sound that does not).
• This parameter appears only if the variation mode is set to
Insertion. The dry/wet balance for System-mode operation
is fixed at D32>W.
0101
1101
D63>W,...,D=W,...,D<W63
5. Controllable parameter
(Only on Variation Edit page; only if mode is Insertion)
• The mark identifies the parameter that can be controlled
in real time with AC1 (Assignable Controller 1).
• This type of control is available only if the variation mode
is set to Insertion, and applies only to the part whose varia-
tion switch is set on.