Filter
Top Products
Other Functions
ZOOM A2.1u
26
3.
Turn parameter knob 2 to select one
of the following functions for the foot
switch.
●
bP (bypass/mute)
The foot switch controls bypass or mute on/off.
This has the same effect as pressing both [W
]/
[Q
] foot switches at the same time in play
mode or manual mode.
●
tP (tap tempo)
Pressing the foot switch repeatedly can be used
to set the interval for the rhythm function or to
make settings for effect parameters supporting
the tap function.
●
bU (bank up)
Each push of the foot switch switches to the
next higher bank. This has the same effect as
pressing the BANK [+] key.
●
rH (rhythm on/off)
The foot switch controls start/stop of the
rhythm function. This has the same effect as
pressing the RHYTHM [R
/P
] key.
●
dH (delay hold)
The foot switch controls on/off of the delay
hold function. When a patch using the hold
function is selected, pressing the foot switch
will activate hold, causing the current delay
sound to be repeated (see illustration below).
Pressing the foot switch once more cancels the
hold condition, and the delay sound will decay
normally.
●
dM (delay input mute)
The foot switch controls muting on/off for the
DELAY input of the DELAY/REVERB
module.
●
Mn (Manual mode)
The foot switch toggles between play mode and
manual mode. This has the same effect as
pressing the [MANUAL] key.
●
Fb (Feedback control)
The foot switch toggles the feedback control
function between on and off. This has the same
effect as pressing the [Q
] foot switch in manual
mode. For details on the feedback control
function, see page 20.
HINT
• For information on effect parameters supporting the
tap function, see pages 30 – 38.
• To use the hold function, an effect type that
supports the hold function must be selected in the
patch. For details, see pages 30 – 38.
• While the DELAY/REVERB module is set to hold or
mute, the dot in the center of the display flashes.
4.
Select the patch in play mode and
operate the foot switch.
The selected function will be activated.
This setting applies to all patches, and the most
recent value is always active. There is no need to
store the setting.
Using the A2.1u as audio
interface for a computer
By connecting the [USB] connector of the A2.1u
to a computer, the A2.1u can be used as an audio
interface with integrated AD/DA converter and
effects. The operating environment conditions for
this type of use are as follows.
■
Compatible operating systems
• Windows XP
•Mac OS X (10.2 and later)
■
Quantization
16-bit
Foot switch is pressed
Foot switch is
pressed again
Original sound
Delay sound
Hold
eA21u.fm 26 ページ ２００５年１１月４日 金曜日 午後５時２３分