Filter
Top Products
ZOOM A2.1u
8
Selecting a Patch
A1
HINT
Turn power on
Set the A2.1u to play mode
Use a shielded cable with mono phone plug
to connect your guitar to the [INPUT] jack of
the A2.1u.
To power the A2.1u from the AC adapter,
plug the adapter into a wall outlet and
plug the cable from the adapter into the
[DC 9V] jack on the A2.1u.
Turn the playback system on and adjust
the volume to a suitable position.
If the Module selector is set to a position
other than "PLAY", set it to "PLAY".
The bank and patch
that were selected
when the power was
last turned off will
appear on the display.
Select a patch
To switch the patch, press one of the [W]/[Q] foot switches.
Pressing the [W] foot switch calls up the next lower patch, and pressing the [Q] foot
switch calls up the next higher patch.
Repeatedly pressing one foot switch cycles through patches in the order A0 – A9 ... d0 – d9
→ 00 – 09 ... 30 – 39 → A0, or the reverse order.
Immediately after turning the A2.1u on,
the unit will be in play mode, even if the
Module selector is set to a position other
than "PLAY".
Set the [POWER] switch on the rear
panel of the A2.1u to ON.
Bank name Patch number
While playing your instrument, try out various patches to see what the A2.1u can do.
eA21u.fm 8ページ ２００５年１１月４日 金曜日 午後５時２３分