Filter
Top Products
Selecting a Patch
ZOOM A2.1u
9
Adjust tone and volume
To adjust the effect sound and volume levels in
play mode, the Parameter knobs 1 – 3 can be
used. Each knob controls a specific parameter.
When you turn a Parameter knob, the corresponding
LED lights up and the display briefly shows the
current value of the respective parameter.
NOTE
• If the MOD/EFX module or DELAY/REVERB
module is set to off for the currently selected
patch (display shows "oF"), the respective
parameter knobs (1 or 2) have no effect.
• Changes made here are temporary and will be
lost when you select another patch. To retain the
changes, store the patch (→ p. 16).
• Besides the individual patch levels, the A2.1u
also allows adjusting the master level. This
setting affects all patches (→ p. 37).
Parameter knob 2
Parameter knob 1
Parameter knob 3
Mainly adjusts the MIX
parameter of the MOD/EFX
module (the level of the
effect sound mixed to the
orignal sound).
Adjusts the PATCH
LEVEL parameter
(output level of the
entire patch).
Adjusts the MIX parameter of the
DELAY/REVERB module (the level of the
effect sound mixed to the orignal sound).
Directly selecting a bank
To select the banks A – d, 0 – 3 directly, use the BANK [-]/[+] keys.
Pressing the BANK [-] key calls up the next lower bank, and pressing the BANK
[+] key calls up the next higher bank.
eA21u.fm 9ページ ２００５年１１月４日 金曜日 午後５時２３分