A SERVICE OF

logo

Installation Guide
22
Mounting the Network Jack
After connecting the Network Jack to the network, use the two
provided screws to mount the Network Jack in any standard
NEMA-WD6 cubicle opening or wall outlet.
If the cubicle or wall opening has a depth of fewer than five
inches, does not support the NEMA-WD6 standard, or does not
have pre-drilled screw holes, mount the Network Jack using the
extension ring, as shown below.
NOTE:
Make sure the vents along the edges of the
Network Jack faceplate are clear of any obstructions.
.3"
1.2"
1.5"
Wall
Standard
wall mount
Extension ring
wall mount
Wall
Extension ring