Installing the Network Jack
23
Connecting the Local Power Supply (Optional)
If your network does not support Power Over Ethernet, or if you
are not using a single-port or multi-port Ethernet power supply,
you must purchase a local power supply from 3Com (see
“Obtaining Optional Components” on page 7). Plug the local
power supply into the power connector located on the bottom
of the Network Jack, and then plug it into any standard electrical
outlet.
Connecting Devices to the Network Jack
After the Network Jack is installed and mounted, connect your
networking devices (such as computers, printers, etc.) to any of
the four switched ports on the front of the Network Jack.
If you installed the adapter plate with pass-through ports,
connect the appropriate device(s) to the port(s).
CAUTION:
Use the local power supply available from
3Com. Failure to do so may result in damage to the
Network Jack, or may result in a hazardous situation.
