Installation Guide
24
Checking the LEDs
You can verify the Network Jack installation by checking the LEDs.
Troubleshooting the Network Jack
If you encounter problems with the Network Jack:
■
Verify the Network Jack is receiving power by viewing the Power
LED (it should be lit). If the Power LED is not lit, make sure the:
■
Power Over Ethernet dip switches are set correctly (for
either Capacitive Power Discovery Process 24V or 48V
or IEEE 802.3af), if your network supports
Power Over Ethernet. See “Setting the Power Over
Ethernet Dip Switches” on page 13 for instructions.
LED Description
(LAN)
■
On—The Network Jack is connected to the network
and a link has been established.
■
Off—There is no connection to the network.
(Power)
■
On—The Network Jack is receiving power (local or
via the network).
■
Off—The Network Jack is not receiving power.
